Instability Warnings in RISA-3D truss models

Are You Receiving Instability Warnings for Your Truss Model in RISA-3D?  If so, Risa News has published some modelling tips to help you resolve those rather quickly.

When running a truss model in RISA-3D, it’s quite common to receive an instability warning, but these can be easily resolved by following a few simple rules.

Rule 1:

Every joint in your model needs to have at least one member with a fixed end release. In trusses, it’s typical to have all members with pinned end releases so be sure to change the end releases to comply with this rule.

Rule 2:

Brace the truss so it doesn’t “flop” out of plane. You can do this by creating an additional boundary condition to brace all of the joints for any out of plane motion. Assuming the truss is in the XY plane, below is the boundary condition you can add:

via Are You Receiving Instability Warnings for Your Truss Model in RISA-3D? « RISA News.

This entry was posted in software, structural and tagged , , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *